Jump to contentJump to page navigation: previous page [access key p]/next page [access key n]
openSUSE Leap Documentation › AutoYaST Guide › Uses for AutoYaST on Installed Systems
ContentsContents
AutoYaST Guide
  1. 1 Introduction to AutoYaST
  2. I Understanding and Creating the AutoYaST Control File
    1. 2 The AutoYaST Control File
    2. 3 Creating an AutoYaST Control File
  3. II AutoYaST Configuration Examples
    1. 4 Configuration and Installation Options
  4. III Managing Mass Installations with Rules and Classes
    1. 5 Rules and Classes
  5. IV Understanding the Auto-Installation Process
    1. 6 The Auto-Installation Process
  6. V Uses for AutoYaST on Installed Systems
    1. 7 Running AutoYaST in an Installed System
  7. VI Appendices
    1. A Handling Rules
    2. B AutoYaST FAQ—Frequently Asked Questions
    3. C Advanced linuxrc Options
    4. D Differences Between AutoYaST Profiles in SLE 42.3 and 15
Navigation←→
openSUSE Leap Documentation › AutoYaST Guide › Uses for AutoYaST on Installed Systems
Top
←→
Applies to openSUSE Leap 15.2

Part V Uses for AutoYaST on Installed Systems Edit source

7 Running AutoYaST in an Installed System

In some cases it is useful to run AutoYaST in a running system.

→Chapter 7 Running AutoYaST in an Installed System←Chapter 6 The Auto-Installation Process
Print this page

© 2020 SUSE