Jump to contentJump to page navigation: previous page [access key p]/next page [access key n]
Start-Up / Installation
Applies to openSUSE Leap 15.4

Part I Installation

  • 1 Installation Quick Start
  • Use the following procedures to install a new version of openSUSE® Leap 15.4. This document gives a quick overview on how to run through a default installation of openSUSE Leap on the x86_64 architecture.

    For more detailed installation instructions see Chapter 3, Installation steps. For installing the AArch64 and POWER variants, see https://en.opensuse.org/Portal:ARM and https://en.opensuse.org/Portal:PowerPC.

  • 2 Boot parameters
  • openSUSE Leap allows setting several parameters during boot, for example choosing the source of the installation data or setting the network configuration.

  • 3 Installation steps
  • This chapter describes the procedure in which the data for openSUSE Leap is copied to the target device. Some basic configuration parameters for the newly installed system are set during the procedure. A graphical user interface will guide you through the installation. The text mode installation has the same steps and only looks different. For information about performing non-interactive automated installations, see Book “AutoYaST Guide.

  • 4 Troubleshooting
  • This section highlights some typical problems you may run into during installation and offers possible solutions or workarounds.