Jump to contentJump to page navigation: previous page [access key p]/next page [access key n]
AutoYaST Guide › Understanding the auto-installation process
ContentsContents
AutoYaST Guide
  1. Preface
  2. 1 Introduction to AutoYaST
  3. I Understanding and creating the AutoYaST control file
    1. 2 The AutoYaST control file
    2. 3 Creating an AutoYaST control file
  4. II AutoYaST configuration examples
    1. 4 Configuration and installation options
  5. III Managing mass installations with dynamic profiles
    1. 5 Supported approaches to dynamic profiles
    2. 6 Rules and classes
    3. 7 ERB templates
    4. 8 Combining ERB templates and scripts
  6. IV Understanding the auto-installation process
    1. 9 The auto-installation process
  7. V Uses for AutoYaST on installed systems
    1. 10 Running AutoYaST in an installed system
  8. VI Appendixes
    1. A Handling rules
    2. B AutoYaST FAQ—frequently asked questions
    3. C Advanced linuxrc options
    4. D GNU licenses
Navigation←→
AutoYaST Guide › Understanding the auto-installation process
Top
←→
Applies to openSUSE Leap 15.6

Part IV Understanding the auto-installation process Edit source

9 The auto-installation process

After the system has booted into an automatic installation and the control file has been retrieved, YaST configures the system according to the information provided in the control file. All configuration settings are summarized in a window that is shown by default and should be deactivated if a full…

→Chapter 9 The auto-installation process←Chapter 8 Combining ERB templates and scripts
Print this page

© 2024 SUSE