Jump to contentJump to page navigation: previous page [access key p]/next page [access key n]
AutoYaST Guide › Uses for AutoYaST on installed systems
ContentsContents
AutoYaST Guide
  1. Preface
  2. 1 Introduction to AutoYaST
  3. I Understanding and creating the AutoYaST control file
    1. 2 The AutoYaST control file
    2. 3 Creating an AutoYaST control file
  4. II AutoYaST configuration examples
    1. 4 Configuration and installation options
  5. III Managing mass installations with dynamic profiles
    1. 5 Supported approaches to dynamic profiles
    2. 6 Rules and classes
    3. 7 ERB templates
    4. 8 Combining ERB templates and scripts
  6. IV Understanding the auto-installation process
    1. 9 The auto-installation process
  7. V Uses for AutoYaST on installed systems
    1. 10 Running AutoYaST in an installed system
  8. VI Appendixes
    1. A Handling rules
    2. B AutoYaST FAQ—frequently asked questions
    3. C Advanced linuxrc options
    4. D GNU licenses
Navigation←→
AutoYaST Guide › Uses for AutoYaST on installed systems
Top
←→
Applies to openSUSE Leap 15.6

Part V Uses for AutoYaST on installed systems Edit source

10 Running AutoYaST in an installed system

In some cases it is useful to run AutoYaST in a running system. Keep in mind that the partitioning section is ignored in this scenario.

→Chapter 10 Running AutoYaST in an installed system←Chapter 9 The auto-installation process
Print this page

© 2024 SUSE